Archive for the ‘Automotive Diagnosis’ Category
Friday, January 14th, 2011 |
Why the cause of white smoke can be determined by oil loss via the valve guides
(1) The negative pressure of the intake manifold is high when the engine is idle, ...
Posted in Troubleshooting | No Comments »
Tuesday, January 11th, 2011 |
Automotive Troubleshooting Oil Loss Via the Piston Ring/the Valve Guides Inspection
Purpose of inspection
When burning oil causes white smoke to be seen in the exhaust gas, changing the engine rpm to ...
Posted in Troubleshooting | No Comments »
Monday, January 10th, 2011 |
Purpose of inspection
To determine whether the malfunction is a rich or a lean air fuel mixture.
Criteria
Using an intelligent tester, check the voltage of the O2 sensor or short term fuel
trim.
The ...
Posted in Troubleshooting | No Comments »
Sunday, January 9th, 2011 |
Purpose of inspection
By confi rming the change in the engine speed when the combustion of each cylinder is stopped in turn for power balance inspection, judge whether or not the ...
Posted in Troubleshooting | No Comments »
Saturday, January 8th, 2011 |
Inspection method
Using a compression gauge, measure the compression pressure.
Criteria
The standard value differs depending on the engine model, therefore refer to the Repair Manual.
When compression pressure is low
Posted in Troubleshooting | No Comments »
Friday, January 7th, 2011 |
Inspection method (gasoline engines)
Inspect the following when cranking the engine.
(1) Pinch the engine compartment fuel hose with your fi ngers and check whether or
not fuel pressure is applied.
(2) Check the ...
Posted in Troubleshooting | No Comments »
Thursday, January 6th, 2011 |
Automotive Troubleshooting Ignition and Glow System Inspection
Inspection method (gasoline engine)
Remove the spark plug and crank the engine to check for a spark at the tip of the plug and the ...
Posted in Troubleshooting | No Comments »
Wednesday, January 5th, 2011 |
Purpose of inspection
The cause of malfunctions related to engine starting differs depending on whether the initial combustion occurs or not, or whether starting takes too much time or not. Therefore, ...
Posted in Troubleshooting | No Comments »
Tuesday, January 4th, 2011 |
Purpose of inspection
Inspect the condition of the ECU (input signal, output signal) when the malfunction occurs and determine the cause by checking the data of ECU.
• Freeze frame data
Freeze frame ...
Posted in Troubleshooting | No Comments »
Pages:
Prev
1
2
3
4
5
6
Next
