When Scrapping Vehicle
M-type airbag/seat belt pretensioners:
Remove the steering wheel pad (with airbag) and front seat outer belts (with seat belt pretensioners) from the vehicle. Unlock the sensor lock and deploy it by subjecting the sensor to a shock by facing the front side downward and dropping it on the ground.
SRS airbag/seat belt pretensioner
Remove the steering wheel pad (with airbag), front passenger airbag assembly, side airbag assembly, curtain shield airbag assembly and/or front seat outer belts (with seat belt pretensioners) from the vehicle. Secure them to a disc wheel or tire with a strong wire harness and deploy by applying electricity to their initiator using the SST.
M-type airbag/seat belt pretensioners:
Same as when scrapping a vehicle.
Disposal
Put the deployed airbag and seat belt pretensioners in a plastic bag, seal the bag tightly and dispose of it as industrial waste.
CAUTION:
1.When the airbag and/or seat belt pretensioners is deployed, each of the parts listed below is very hot, so leave it alone for at least 30 minutes after deployment.
Steering wheel pad (with airbag)
Front passenger airbag assembly
Front seat outer belt (with seat belt pretensioners)
Side airbag assembly
Curtain shield airbag assembly
2.Use gloves and safety glasses when handling each of the parts listed below. In addition, do not apply water to then.
Steering wheel pad with deployed airbag
Deployed front passenger airbag assembly
Front seat outer belt with deployed seat belt pretensioners
Deployed side airbag assembly
Deployed curtain shield airbag assembly
3.Always wash your hands with water after completing the operation